Precision Planting RowFlow 20/20 - Page 23

955205_01 11/11 23
GPS Setup – Sidedress Bar
From the Home Screen, press Setup-Systems-
GPS-Sidedress Bar to enter the GPS
measurements for the bar. Frame Type is locked
on Single. Press Hitch Style to select Drawn,
2-Point Pivot, or 3-Point and press Enter. The
“A” measurement is measured from the pivot
point at the hitch to the center of the transport
wheels. The “B” measurement is measured
from the pivot point at the hitch to the point of
applicaon. The “C” measurement is the
eecve width of the bar, not the actual
measured bar width (lemost point of
applicaon to the rightmost point).
Setup and Operaon (Sidedress)
Motor Calibraon
Liquid motor calibraon is accessed from the
same motor setup screen. Press Motor
Calibraon at the top and then press the Gear
Rao buon. Enter the gear rao calculated
using the formula provided on this page and
then press Enter. If the Drive Motor is directly
coupled to the liquid pump, the Gear Rao will
be “1”. Press the Liquid Rao buon to open
the liquid motor calibraon screen. If you know
the number of ounces of product produced by
one pump revoluon, you may enter it here and
press Enter. You may also do a Liquid Run Cal to
get this number by pressing the buon at the
right side of the screen.
Motor Setup
Setup for liquid control motors can be accessed
from the standard RowFlow motor setup screen
for or by going to Setup-Systems-RF Liquid.
Select Drive Motor #2 and press Liquid. Select
the correct motor brand and then enter the
default rate at which you would like your
product to be applied and press Enter. Enter the
maximum speed (in RPM’s) for the liquid pump
as dened by the pump’s manufacturer
specicaons and then press Enter.