Precor AMT 885 - Page 20

13
Level the AMT
It is important to level the AMT properly every time you move it.
CAUTION
To eliminate movement, make sure the adjustable feet are in
contact with the floor. Also, make sure that the AMT sits on a flat
surface. Adjusting the feet of the AMT cannot compensate for
extremely uneven surfaces.
To level the AMT:
1. Try to rock the AMT while standing on one of its foot plates and grabbing the
opposite handlebar. If there is any movement, with assistance, tip the AMT to
one side to locate the adjustable feet.
2. Using a 9/16-inch open-ended wrench, move the jam nuts away from the side
arm supports and toward the adjustable feet.
3. Correct the height of each adjustable foot as follows (see Figure 21):
Figure 21
If you want to ... Then turn the adjustable feet …
Raise the front end of the AMT Counterclockwise
Lower the front end of the AMT Clockwise
Important To allow the rear pedestal to fit properly, the adjustable feet must extend at
least 2 inches (5 cm) below the side arm supports. Extend the feet before you remove the
spacer block (as described in To add the side arm supports), to ensure that they are
positioned correctly.
4. When you finish adjusting the equipment, recheck for movement and readjust as
necessary.
5. Using the 9/16-inch open-ended wrench, move the jam nuts upward until they
contact the side arm supports and fully tighten them.
6. Align the rear pedestal over the back frame tube and the side arm covers, then
press the pedestal into place (see Figure 22).
Figure 22