P62 CONSOLE
GETTING STARTED GUIDE
P62 Console Getting Started Guide | P/N 304240-101 rev A, ENU
©2016 Precor Incorporated | August 2016
Welcome to a personalized fitness experience for your members
The intuitive high-definition touchscreen, easy-to-reach single or dual motion controls, and built-in fitness tutorials makes the P62
Console a unique fitness experience for your members and trainers.
Set up the console
The P62 console has a built-in Administrator
account for owners.
The Settings menu is visible only to administrators
and registered service technicians. Changes made to
these settings are saved to the fitness equipment.
An Administrator uses a password (see below) to
access and configure the console settings to improve
an exerciser's workout and benefit the facility.
To change system settings:
Setting Information
Press and hold Volume Down.
Press Channel in the following order:
Channel Up
Channel Down
Channel Down
Channel Up
Enter the password: 5 6 5 1 5 6 5
Touch OK. The System Settings banner
appears.
About Displays serial number and event log.
Equipment Use Gathers data on individual and cumulative equipment use
System Settings Connectivity: Determines network type (Wired and Wi-Fi)
and IP address.
TV settings: Sets up channels and close captions
Workout limits: Sets limits on equipment use during peak
hours, maximum treadmill speed, or maximum pause time.
For complete console operating instructions and troubleshooting, visit us at www.precor.com.
To Next Page
Loading...
