page 24
COMMERCIAL PRODUCTS DIVISION
REMOVING OR PROVIDING A FITNESS TEST
The Fitness Test is “enabled” at the factory (course number 16), so if you wish to
remove the option from the user’s choice of programs on the C966, you need to
“disable” the Fitness Test.
Important: If you “disable” the Fitness Test, it is no longer available to the user.
Custom Course 2 takes its place as course number 16.
After displaying a cool down time limit and entering your selection, the Fitness Test
prompt appears on the display. Use the ▼▲ keys to select “enabled” or “disabled”.
Press Enter to confirm your selection.
CHANGING THE CUSTOM COURSES
Two custom course programs (Course 1 and Course 2) exist in the C966 treadmill.
After you modify Course 1 (or opt to bypass it), Course 2 appears on the display.
The keys on the console keypad have a different function than explained in the
box on page 21. In the Custom Course programs, the keys function as follows:
Custom Course Program Keys
Speed ▼ or ▲ moves the blinking LED from column to column.
Incline ▲ or ▼ affects the incline of the selected column.
Enter accepts any changes and stores the course in memory.
Stop or Reset exits the course (leaving it unchanged) and resets the
display to the Precor banner.
If you decide to select a custom course, you have the ability to create a new, or
“draw over” an existing, course profile. The entire course appears on the display. A
blinking LED appears at the top of the far left column and indicates the starting
position. Any incline changes that you make occur only in that column. The
treadmill’s speed is determined by the user.
Begin modifying the course profile using any Incline ▲ or ▼ key. The available
incline range is a negative 3% to a positive 15%. To move onto the next column,
press any Speed ▼ or ▲ key. (Refer to the chart above.)
When you have finished making changes, press Enter to save the course profile.
The display moves to the next Custom Course (#2) or returns to the Precor
banner (depending on which Custom Course you were modifying).
Note: To exit the custom course mode without saving any of the changes, press
Stop or Reset. The custom course that existed prior to your changes is reinstated
and the display returns to the Precor banner.
VIEWING THE ODOMETER, HOURS OF USE, SOFTWARE
VERSION, ERROR LOG AND SERIAL NUMBER
The treadmill stores the cumulative miles or kilometers, the number of hours that
the unit has been in use, the software version and software type (which is valuable
when calling customer support), and an error log (useful when troubleshooting).
To Next Page
Loading...
Need help?
Power
Performance
Weight and Dimensions
