28 Assembling and Maintaining Elliptical Fitness Crosstrainers: EFX 883 / 833 / 813
To tighten the fasteners properly:
CAUTION: Upright support fasteners must be properly aligned
and wrench-tightened in the order described below. If improperly
assembled, the upright supports can rub against the ramp. Before
you begin, verify that the base and lift covers are properly aligned
and that the gap between them is even. If not, move the upright
supports until the covers are properly aligned.
1. Fully tighten the two sets of fasteners on the back of the
center column support.
Figure 10: Fastener attachment detail
2. Fully tighten the fasteners on the back of each upright
support.
Figure 11: Tighten the back fasteners on the upright supports
To Next Page
Loading...
