Adjust the running belt (treadmill only)
If you are unsure about adjusting the running belt, contact Precor Customer Support.
Take special care when aligning the running belt. The treadmill will not stop immediately if an
object becomes caught in the belt or rollers. Turn OFF the treadmill while adjusting or
working near the rear roller. DO NOT wear loose clothing or allow your hair to hang loose
during this procedure. DO NOT adjust the running belt when someone is standing on it. Keep
your fingers and any other object clear of the belt and rollers, especially in front of the roller
Make all belt adjustments on the adjusting bolts at the rear corners of the treadmill using the hex key provided,
and DO NOT turn either bolt more than ¼ turn before checking the alignment of the running belt again.
Overtightening the adjusting bolts can damage the treadmill.
To adjust the running belt:
1. Locate the adjusting bolt in the right side end cap at the rear corner of the
treadmill (Figure 1).
2. Use the hex key to tighten the adjusting bolt in the direction that the belt is
shifting. Turn the bolt ¼ turn clockwise.
Continues to shift in the original
direction
Turn the
adjusting bolt an
additional ¼ turn clockwise.
Starts to shift in the opposite
direction
Turn the
adjusting bolt ⅛
turn or less counterclockwise.
3. Recheck the belt position as described in Check the Alignment of the running belt.
If the belt slips after you have adjusted it, tighten the adjusting bolt evenly, ¼ turn at a time, until the slipping stops. DO NOT overtighten the belt.
8
To Next Page
Loading...
