P94 (22”) AND P84 (16”) TOUCHSCREEN CONSOLES
GETTING STARTED GUIDE
Precor P94 and P84 consoles offer the best blend of performance, tness and entertainment. With workouts that delight, wireless casting that embraces the
phone, and hassle-free media alternatives, exercisers will keep their eyes on the big screen where your impact happens.
Set Up the Console
The P94 and P84 Consoles have built-in Administrator accounts for
owners. The Settings menu is visible only to administrators and
registered service technicians. Changes made to these settings are
saved to the tness equipment. An Administrator uses a password
(see below) to access and congure the console settings to enhance
an exerciser’s workout as well as benet the facility.
© Peloton Interactive, Inc. P94 and P84 Touchscreen Consoles | Getting Started Guide | 306877-101 ENU | 31 August 2023 | 1 of 2
Change System Settings
1. Press and hold the Stop button for 7 seconds. The password page
appears.
2. Enter the password 5 6 5 1 5 6 5
3. Press OK. The System Settings page appears.
P94 22” Touchscreen
(Dual Paddle Option)
P84 16” Touchscreen
(Single Paddle Option)
Settings Menu
About Displays serial number and event log
Equipment Use Individual and cumulative equipment use data
System Settings Connectivity: Determines network type (Wired and Wi-Fi) and IP address.
Display: Customizes language, time zone, and date format.
TV settings: Sets up channels and close captions.
Workout limits: Sets limits on equipment use during peak hours, limits
maximum treadmill speed or maximum pause time.
Safety Code Allows facilities to toggle on or off a PIN which must be entered to use
equipment. The PIN is 1 2 3 4.
Get to Know the Console
The Consoles feature either single or dual-motion controls, an LCD touchscreen with streaming media and TV options, and have connected tness
capabilities.
Incline or stride height* indicator
Intensity or resistance indicator
Audio jack
*Stride height indicator for AMT only. Incline indicator is on the dual-
motion control. The motion control(s) are located below the indicator.
NOTE For networked equipment, a technician can update software over the network. For non-
networked equipment, a technician uses a USB drive to update each machine.
To Next Page
Need help?
General
