Rewire the Treadmill
T
o thread the PVS power and television cables through the treadmill, refer to the
following table and gure:
Step Procedure
Remove the console back cover, then the top cover on the upright
support.
Remove the hood and blank panel.
Thread the cables through the console mount. Secure them using the
three wire retainers and route the cables behind the spacer ring,
identied by an arrow in the gure.
Route the cables down the cable channel in the upright support.
Pull the cables from the bottom of the right upright support and
thr
ead them across the base frame. Secure them with wire retainers.
N/A Thread the cables downward through the opening in the base frame
and pull the cables out through the opening at the base of the unit.
N/A Reattach the top cover on the upright support.
Important Do not pinch the cables when reinstalling the plastic covers.
Attach the new jack panel (in the hardware kit) to the base frame
using the two scr
ews that attached the blank panel.
6
To Next Page
Loading...