Rewire the 800/600 EFX
Step Procedure
On the center column, lift the moisture seal upward and remove it.
Remove the front top cap from the center column.
To remove the bottle holder, strike the plastic parts of either side (see
gr
ey circle in graphic) with the heel of your palms. The holder pops
off.
Slide the front cover off.
Remove the two screws that secure the blank jack plate and set them
aside.
Attach the following cables to both sides of the new jack plate:
A Communication cable
B T
elevision (coax)
C Power cable
Use the wire retainers to hold the cables in place.
N/A Attach the new jack plate using the two screws removed in step 5.
Feed the cables up the EFX neck and out the opening at the top.
N/A Reattach the covers and parts removed in steps 1 through 4.
7
To Next Page
Loading...