Page 8 K&(%$*4.8"4,7%R'*#$"&8#J%/7*,#*%4,77%PSTTTSTQQSUVWV1 ITEM 69727
F=K6EB F6E;X CX6I=E@C> D=@>E6>=><6
C/*(,$"&8%
I*,9%$.*%6>E@I6%@DXCIE=>E%F=K6EB%@>KCID=E@C>%#*4$"&8%,$%$.*%+*3"88"83%&2%$."#%5,8',7%
"847'9"83%,77%$*G$%'89*(%#'+.*,9"83#%$.*(*"8%+*2&(*%#*$%'/%&(%'#*%&2%$."#%/(&9'4$1
X(*SF$,($%<.*4a#
Inspect engine and equipment looking for damaged, loose, and missing parts before set up and starting.
If any problems are found, do not use equipment until fixed properly.
<.*4a"83%,89%K"77"83%683"8*%C"7
>CE@<6-%%B&'(%Y,((,8$H%"#%!C@L%"2%$.*%*83"8*j#%
4(,8a4,#*%"#%8&$%/(&/*(7H%2"77*9%)"$.%&"7%+*2&(*%
*,4.%'#*1%%[*2&(*%*,4.%'#*J%4.*4a%$.*%&"7%7*M*71
Engine%)"77%8&$%#$,($%)"$.%7&)%&(%8&%*83"8*%&"71
1. Make sure the engine is stopped and is level.
2. Close the Fuel Valve.
3. Clean the top of the Dipstick and the area around it.
Remove the Dipstick by turning it counterclockwise,
and wipe it off with a clean, lint free rag.
4.
Full level
Full level
Reinsert the Dipstick without threading it in and
remove it to check the oil level. The oil level
should be up to the full level as shown above.
5. If the oil level is at or below the low mark add the
appropriate type of oil until the oil level is at the
proper level. SAE 10W-30 oil is recommended for
general use. (The SAE Viscosity Grade chart on
page 13 in the Maintenance section shows other
viscosities to use in different average temperatures.)
6. Thread the dipstick back in clockwise.
>CE@<6-%%L&%8&$%('8%$.*%*83"8*%)"$.%$&&%7"$$7*%&"71
Engine%)"77%#.'$%&22%"2%*83"8*%&"7%7*M*7%"#%$&&%7&)1
To Next Page
Loading...
Need help?
General
