Page 12
For technical questions, please call 1-888-866-5797.
ITEM 59135
SAFETY OPERATION MAINTENANCESETUP
Starting the Engine
Before Starting the Engine
a. Inspect the generator and engine.
b. Disconnect all electrical loads from the generator.
c. Fill the engine with the proper amount and type of
both stabilizer-treated unleaded gasoline and oil.
Manual Start
1. Open vent on Gas Cap.
2. Move the Economy (ESC) Switch
to the OFF position.
3. Turn the Combination Switch
to the START position.
4. Grip the Starter Handle of the Engine loosely and
pull it slowly several times to allow the gasoline to
flow into the Engine’s carburetor. Then pull the Starter
Handle gently until resistance is felt. Allow
Cable to retract fully and then pull it quickly.
Repeat until the Engine starts. Do not let the
Starter Handle snap back against the housing.
Hold it as it recoils so it doesn't hit the housing.
Note: If engine does not start, check engine oil level.
Engine will not start with low or no engine oil.
Note: If warm engine does not start, turn Combination
Switch to RUN before trying to start it again.
1
2
3
4
To Next Page
Loading...
