Page 20
For technical questions, please call 1-888-866-5797.
ITEM 59135
SAFETY OPERATION MAINTENANCESETUP
Engine Oil Change
CAUTION! Oil is very hot during operation and can cause burns. Wait for engine to cool before changing oil.
1. Make sure the engine is stopped and is level.
2. Close vent on Gas Cap.
3. Remove the Access Panel on the
right side of the Generator.
4. Clean the top of the Oil Fill Plug and the
area around it. Remove the Oil Fill Plug,
turning it counterclockwise.
5. Place the Generator on stands with the oil
fill centered over an oil drain pan. Tilt the
Generator over the oil drain pan and wait for
oil to drain completely. Recycle used oil.
6. Set the Generator back down on a level surface.
Add the appropriate type of oil until
the oil level is at the proper level.
SAE 10W-30 oil is recommended for general use.
7. Check the oil level. The oil level should be
up to the edge of the hole as shown.
8. Thread the Oil Fill Plug back in clockwise
and replace the Access Panel.
NOTICE: Do not run the engine with too little oil.
Engine will not start with low or no engine oil.
Full level
To Next Page
Loading...
