Predator 59186 - Engine Starting and Operation

Page 12
For technical questions, please call 1-888-866-5797.
ITEM 59186
SAFETY OPERATION MAINTENANCESETUP
Starting the Engine
Before Starting the Engine
a. Inspect the generator and engine.
b. Disconnect all electrical loads from the generator.
c. Fill the engine with the proper amount and type of
both stabilizer-treated unleaded gasoline and oil.
Manual Start
1. Open vent on Fuel Cap.
2. Turn the Engine Switch
to the ON position.
3. Move the Choke Lever to the
START (closed) position.
4. Move the Economy (ESC) Switch
to the OFF position.
5. Grip the Starter Handle of the Engine loosely and
pull it slowly several times to allow the gasoline to flow
into the Engine’s carburetor. Then pull the Starter
Handle gently until resistance is felt. Allow
Cable to retract fully and then pull it quickly.
Repeat until the Engine starts. Do not let the
Starter Handle snap back against the housing.
Hold it as it recoils so it doesn't hit the housing.
Note: If Engine does not start, check engine oil level.
Engine will not start with low or no engine oil.
Note: If warm Engine does not start, move the Choke Lever
to the RUN (open) position before trying to start it again.
OVERLOAD
GROUND
USB 5V DC
PARALLEL
OUTLETS
AC 120V
ESC THROTTLE
OUTPUT
CARBON
MONOXIDE
SHUTOFF
DC 5A
12V DC 5A
1.0A
2.1A
OFF
ON
RESET
1
ON
2
ON
OVERLOAD
GROUND
USB 5V DC
PARALLEL
OUTLETS
AC 120V
ESC THROTTLE
OUTPUT
CARBON
MONOXIDE
SHUTOFF
DC 5A
12V DC 5A
1.0A
2.1A
OFF
ON
RESET
3
START
OFF
RUN
4
ON
OFF
OVERLOAD
GROUND
USB 5V DC
PARALLEL
OUTLETS
AC 120V
ESC THROTTLE
OUTPUT
CARBON
MONOXIDE
SHUTOFF
DC 5A
12V DC 5A
1.0A
2.1A
OFF
ON
RESET
5