Page 12 R&(%$*4.8"4,7%T'*#$"&8#Q%/7*,#*%4,77%=>???>?AA>UVBV1 ITEM 63406
MDR6LI M6LC[ J[6PDLGJE KDGEL6EDE<6
K,8',7%M$,($
1. To start a cold engine, move the Choke to the
START position.
To restart a warm engine, leave the
Choke in the RUN position.
2. Open the Fuel Valve.
3. Slide the Throttle or Speed Control Lever to 1/3
away from the SLOW position (the “turtle”).
4. Turn the Engine Switch on.
E&$*- If engine does not start, check engine oil level.
Engine will not start with low or no engine oil.
5. Grip the Starter Handle of the Engine loosely and pull
it slowly several times to allow the gasoline to flow into
the Engine’s carburetor. Then pull the Starter Handle
gently until resistance is felt. Allow Cable to retract fully
and then pull it quickly. Repeat until the engine starts.
E&$*- Do not let the Starter Handle snap back against the engine.
Hold it as it recoils so it doesn't hit the engine.
START RUN
1
2
3
JE
JRR
J
G
JE
4
5
To Next Page
Loading...
