Predator 63406 - Engine Operation and Break-in; Stopping the Engine; Engine Break-in Period

Page 13R&(%$*4.8"4,7%T'*#$"&8#Q%/7*,#*%4,77%=>???>?AA>UVBV1ITEM 63406
MDR6LIM6LC[J[6PDLGJEKDGEL6EDE<6
6. Allow the Engine to run for several seconds.
Then, if the Choke lever is in the START position,
move the Choke Lever very slowly to its RUN position.
E&$*- Moving the Choke Lever too fast could stall the engine.
GK[JPLDEL- Allow the engine to run at no load for five minutes with no
load after each start-up so that the engine can stabilize.
7. Adjust the Throttle as needed.
8. ](*,d>"8%[*("&9-
a. Breaking-in the engine will help to ensure proper equipment and engine operation.
b. The operational break-in period will last about 3 hours of use. During this period:
• Do not apply a heavy load to the equipment.
• Do not operate the engine at its maximum speed.
c. The maintenance break-in period will last about 20 hours of use. After this period:
• Change the engine oil.
Under normal operating conditions subsequent maintenance follows the schedule
explained in the MAINTENANCE AND SERVICING section.
M$&//"83%$.*%683"8*
1. To stop the engine in an emergency,
turn the Engine Switch off.
2. Under normal conditions, use the following procedure:
a. Slide the Throttle or Speed Control
Lever to SLOW (the “turtle”).
b. Turn the Engine Switch off.
c. Close the Fuel Valve.
NOTICE
See “Long-Term Storage” on page 16
for complete storage instructions.
START RUN
6
J
G
JRR
J
G
JRR