Page 16 For equipment technical questions, please call 1-888-866-5797. ITEM 64931
SAFETY SETUP OPERATION MAINTENANCE
Stopping the Engine and Pressure Washer
1. To stop the engine in an emergency,
turn the Engine Switch off.
2. Under normal conditions, use the following procedure:
a. Release the Trigger on the Spray Gun handle.
b. Slide the Throttle to the SLOW
position (the “turtle”).
c. Turn the Engine Switch off.
d. Close the Fuel Valve.
e. Turn the water supply off.
3. Point Spray Gun in safe direction and squeeze
Trigger 5 seconds to release excess pressure.
4. If pressure washer detergent has been used,
run clean water through the system to eliminate
detergent residue using the following procedure:
a. Turn off the Engine as detailed in step 2.
b. Remove the Nozzle and Detergent Siphon
Tube and soak in a container of clean water.
c. Turn on the water supply and restart
the Engine following directions in
Starting the Engine on page 13.
d. Point Wand in safe direction and hold down
Trigger to flush water through system until clean.
e. Turn off the Engine as detailed in step 2.
Storing
1. Disconnect the water supply hose from the
water inlet connection on the Pump.
2. Drain all water out of the Pressure Washer and lock
the Trigger. Clean external parts with clean cloth.
3. Disconnect the Pressure Hose from the Pump
and Spray Gun, drain water from Hose and coil.
4. Loosen the nut and remove the
Wand from the Spray Gun.
5. Cover and store in a dry, level, well-ventilated
indoor area out of reach of children. Storage area
should also be away from ignition sources, such as
water heaters, clothes dryers, and furnaces.
NOTICE
Drain fuel at end of season or warranty is void.
See Long-Term Storage on page 20 for complete storage instructions.
OFF
OFF
ON
To Next Page
Loading...
