For Easiest Assembly:
• To avoid losing any small components or hardware, assemble your product on a
hard level surface that does not have cracks or openings.
• Clear an area large enough to layout all components and hardware.
• When applicable, tighten all hardware connections by hand rst. Once the step
is completed go back and fully tighten all hardware.
• Follow all steps in order to properly assemble your product.To complete assem-
bly you will need:
• (1) Leak Detection Solution (Instructions on how to make solution are included in
“Operating Instructions” section)
• (1) precision-lled standard grill gas tank with external valve threads.
Note: You must follow all steps to properly assemble your Predator Dynamic.
Typical assembly: approximately 30 minutes.
A. Hat
B. Rapid Action Attractant (remove sealing before use)
C. Multi attractant compartment
D. CO
2
Engine
E. Rapid Action Sticky Paper
F. Gas hose and hoseclamp
G. Country specific regulator (see specifications page 11)
H. Insect collector and Water trap
I. Pole: Asian Tiger mosquito mode
J. Pole: Mosquito mode (standard)
K. Pole: Midge and Gnat mode
L. Legs
M. Gas tank base
N. Anchor stakes
O. Safety lock
P. Gas tank 10 kg (recommended)
To Next Page
Loading...