Predator Dynamic - Insert the gas cylinder into the base and tighten the safety lock; Insert the battery into its chamber; Start the engine

Predator Dynamic
Igniter Button
Control Valve
Button
6
Assembly instructions
Insert the battery into it´s chamber:
Open battery compartment by turning cap, located underneath
CO
2
engine, counter clockwise.
Test ignitor by pressing the red button. Listen for clicking sounds.
Start the engine:
Open gas tank valve COUNTER CLOCKWISE, fully.
Turn back a quarter of a turn CLOCKWISE.
1. Press and hold black control valve button.
2. IMMEDIATELY press and hold the red igniter button down until
you hear a “POP” sound indicating ignition. Normally occurs
within 20 seconds.
3. Continue to hold black control valve button for 30 seconds.
4. The needle on the engine gauge should begin to move into the
“Green” zone. Within minutes LED lights will be flickering and the
vacuum fan will be running with air flow out of the engine bottom,
indicating the Predator Dynamic is ready to operate.
CAUTION: If engine fails to light, shut gas off at tank and wait
5 minutes before attempting to restart the engine by following the
lighting instructions.
4
5
6
Insert the gas cylinder into the base and tighten the safety lock:
WARNING:
Change the gas cylinder in a well ventilated area, away from any
ignition source (candle, cigarettes, or open flame)
Do not obstruct the ventilation holes of the cylinder enclosure.
Use only the type of gas and the type of cylinder specified by the
manufacturer.