11
TROUBLESHOOTING GUIDE
PROBLEM
No response when the
power is turned on
Power cord unplugged.
Plug power cord firmly into electrical outlet in
wall.
Defective power cord.
Check all connections and condition of cords.
Do not operate with damaged power cord(s).
Tripped circuit breaker.
Reset breaker for building.
Reset 12 amp breaker located on unit.
Tripped ground fault circuit
interrupter or residual current
device.
Reset GFCI on control panel or GFCI/RCD at
the power source.
Note:
Unit must be plugged in when resetting
GFCI on control panel.
Thermal overload on the
motorized impeller has tripped.
Turn unit "OFF", wait 30 minutes and restart
unit.
Circuit breaker on
control panel or
Overloaded circuit.
Unplug any additional equipment connected
to the circuit. Reset circuit breaker.
Filter change indicator
is ON”.
Loaded filters.
Change in accordance with operating
instructions.
Excessive restrictions.
Reduce bends, length of flex duct, or
eliminate restrictions.
If using a carbon pre-filter,
carbon filter has not been
removed from polybag.
Remove carbon filter from polybag.
Note:
If the unit does not start or malfunctions after carefully following the TROUBLESHOOTING GUIDE, call
Abatement Technologies service department at +1 800-634-9091 (U.S.) or +1 905-871-4720 (Canada) for
assistance.
To Next Page
Loading...