Figure 1: Put ingredients to be ground into Jar.
Figure 2: Invert Base onto Jar and turn in clock-wise direction, till it is properly locked.
Figure 3: a. Seat Assembly on Top Cap ensuring that the Base Locks fit properly in the
grooves of the Top Cap.
b. Inch 5 to 10 times.
c. Grind on Speed 1 only.
d. NEVER GRIND FOR MORE THAN 1 MINUTE CONTINUOUSLY. If you
need to grind for more than 1 minute, STOP MIXIE FOR 1 MINUTE &
THEN GRIND AGAIN.
If the appliance is run for more than 1 minute while dry grinding, the contents
will get excessively hot and can cause the Jar to warp out of shape.
Figure 4: After grinding, remove Assembly from Mixie by holding the Base, twisting
anticlockwise and lifting off the Top Cap.
Figure 5: Invert Assembly, hold the Jar with one hand and twist open anti-clockwise, to
release the Jar.
Figure 6: Allow contents to cool and then twist the Cap clockwise on the Jar to seal air-
tight, ensuring that the‘O’ Ring is in place.
Figure 7: The Grind n’ Store can be used as a Chutney Grinder by using the
Chutney Grinder Lid instead of the Jars.
Caution : 1. NEVER LEAVE BASE ALONE ON MIXER.
2. NEVER OPERATE UNLESS JAR IS PROPERLY LOCKED
ON THE BASE.
WARNING: Improper use of appliance without locking Jar onto Base
can cause serious injury.
HOW TO USE YOUR GRIND N’ STORE
1
2
3
Grind & Store Chutneys, Spices, Coffee Powder...
Separate Jars for each Spice or Chutney.
Airtight Cap keeps contents fresh.
Refrigerate and use as Serving Bowl.
4
5
6
7
Grind n’ Store
7
To Next Page
Loading...