Premier designs Eagle - Page 4

6
7
5
Insert the Underwing Spreader into the hole in the zipperd body.
Make sure the dihedral is positioned correctly and insert the
Underwing Spreader into the dihedral. Zip up the body. Stretch the Wing Tension Bungee Loops over the Wing Tip Nocks.
6
Insert remaining end of the Underwing Spreader into the
Outer Leading Edge Connector. Connect both Stand-offs into
the Stand-off Connectors on the Underwing Spreader.
Repeat 4 & 5 with second Underwing Spreader on other side.
7
Flip the kite over. Slide the Tail Spreader under the loops at the middle of
the tail. Insert the ends of the Tail Spreader into the pockets on each side
of the tail. Make sure the tail points upward. If necessary, rotate
the ferrule inside the spine sleeve until the tail points upward.
4
Insert Underwing
Spreader through the
hole in zippered body
and into the dihedral.
Bungee
Nock
Outer Leading
Edge Connector
Stand-offs
Slide Tail Spreader
through loops and
into pockets
Loops Pocket
Correct Tail Position
Incorrect Tail Position
IMPORTANT!