31
Valley Connections – Premier Panels can be
used in hips and valleys. Consult with your
Premier Sales Professional and the Premier
Detail manual for more information.
Ridge Cap – Begin by trimming off 1/2” from the
bottom of the ridge cap point. Spray a high-yield,
expanding foam into the bottom and along the
sides of the ridge and set the ridge cap in place.
Adhere two strips of OSB to the top of the ridge
using Premier Mastic and Panel Screws.
Vapor Retarder – An appropriate vapor
retarder must be installed on the interior
of the roof panels. Premier recommends
using SIP tape on the panel joints and
at the wall to roof connections. Refer to
Technical Bulletin #28 at www.pbssips.
com for more information on this subject.
To Next Page
Loading...