3.) Attach front wheel
This is the same method as any quick release bicycle wheel. It’s easier if you flip the
cycle upside down in this step.
1. Undo the Quick-release on the front wheel and loosen the nut
2. Insert the centre axle
3. Adjust the front wheel. Tighten the nut so when locking the quick release it is
firm but not impossible to close.
4. Ensure that the dic brake rotor fits firmly in the disc brake caliper.
5. Lock off the Quick-release
When fastening the nut for front wheel hub, press down the front fork so that the front
wheel hub fits snug with the front fork.
To Next Page
Loading...