4c.) Attaching left hand pedal
As with the right hand pedal, you will need to screw the left pedal in by the axle. It is
very important to start by!screwing the!Left!pedal BY HAND into the crank arm in
an!Anti-clockwise!direction (opposite to normal threading), or towards the front of the
bike. It should go in easily.
When it gets to the end, use the spanner or Allen key to tighten it fully. Use only a
small amount of force to tighten.
4d.) Removing pedals
You may need to remove the pedals at some point. It is as simple as attaching them.
Using a pedal spanner or Allen key, loosen the pedals by turning towards the rear of the
bike or an Anti-clockwise position for the Right and a Clockwise position for the Left.
To Next Page
Loading...