Premium PPA1208J - Section One Maintenance for Common Trouble; Chapter I Trouble Analysis

2
Section One
Maintenance for Common Trouble
Chapter I Trouble Analysis
When trouble happened, don’t get panicky and take apart the machine without any
analysis, otherwise some unnecessary damages will be caused. Please deal with the
trouble as the following to find a correct solution.
If the trouble cannot be solved by the following solutions, please check special
trouble solutions for help.
Trouble Cause Solution
Machine cannot work
1. Power-off
2. Power plug is loose
3.Water-full indicator turns on or “P2”
flashes on screen
1.Power-on
2.Re-insert power plug
3.Drain out the water
Cooling function cannot work
well
1.Filters are blocked by dusts
2.Air-inlet is blocked
3.The room is too big or blow-by
1.Clean filters
2. Remove the blockage.
3. Adjust room area or strengthen
the seal
Water leakage
1.Machine doesn’t stand upright
2.Water-outlet is blocked
1 Let machine stand upright
2. Unchoke water-outlet.
Abnormal noise of machine
1.Machine is not placed well
2.Filters is blocked
1.Let machine on flat place and
stand upright
2. Clean the filters
Heat air doesn’t go out
immediately under heating
mode.
1.Environment
al temperature is higher
than setting temperature
2.Heat air will blow out three minutes later
after heating mode running
1.Make setting temperature is
higher than environmental
temperature
2.Please wait patiently for three
minutes.
Strange smell blows out
Machine is unused for a longtime, it has
adsorbed the smell from furniture , carpet,
paint. when the machine runs, the smell
will blow out
Run machine for 2-5minutes, the
strange smell will disappear.