Installation Instructions for Web Slide Exercise Rail
Single Rail – Concrete/Block
(Do not mount in or around pool area.)
TOOLS REQUIRED
Electric drill, 5/16" concrete drill bit and a level.
Important: These instructions are specific to mounting on concrete or
block.
If you are mounting to a wood or steel stud please
see instructions specific to drywall on reverse.
Exercise Rails
1) Position rail in desired location. If mounting multiple rails begin with the
bottom rail at floor level or just above the baseboard. See mounting options
on the reverse side of the Package Contents sheet.
a. Using a level, adjust the Rail until it is plumb.
b. Mark the wall with a pencil using the mounting holes of the Rail as guides.
2) Drill marked holes 5/16" x 2-1/4" deep.
3) Install the 1-1/2" lead anchors provided (C).
4) Attach Rail with the 3" screws provided (B).
5) Tighten until Rail rests snugly against wall. DO NOT OVER-TORQUE.
6) Apply rail slot number labels next to each slot in rail. Peel off backing (D) and
stick.
7) SAFETY SLIDE - Store Safety Slide in round holes on left side of rail. One
Safety Slide per rail (A).
• IF MOUNTING IN AN ENVIRONMENT SUBJECT TO MOISTURE CALL
800.544.7257 FOR PROPER MOUNTING HARDWARE.
• DO NOT INSTALL IN A POOL AREA
• IF ANY OF THE SCREWS ARE OVER TORQUED AND STRIPPED, THE
UNIT CANNOT BE SAFELY USED
• DO NOT USE IF ANY OF THE SAFETY SLIDES ARE MISSING. CALL
FOR REPLACEMENTS
• PRIOR TO EVERY EXERCISE SESSION, CHECK TO MAKE SURE THE
SCREWS ARE SECURELY FASTENED TO THE WALL & SHOW NO
SIGNS OF CORROSION.
To Next Page
Need help?
General