STAGE
DigiMax D8 rear
DigiMax D8 rear
DigiMax D8 rear
FireStudio Lightpipe front
FireStudio Lightpipe rear
FOH Digital Console
Analog Monitor Mixer
24 Channel TRS-TRS snake
24 Channel XLR (F) - XLR (M) sanke with Stage Box
75 ohm BNC
75 ohm BNC
75 ohm BNC
ADAT
BNC T-Connector
(F-F-F)
BNC T-Connector
(F-F-F)
BNC T-Connec
tor
(F-F-F)
FW400 cable
Laptop
This diagram shows the DigiMax D8 used as a splitter; sending the analog direct outputs to an analog monitor mixer and the ADAT output to a digital
Front of House console. The digital outputs of the FOH console are then being sent to the FireStudio Lightpipe so that the performance can be recorded
on a computer. The entire digital signal path is being clocked to the digital console via BNC, so the 3 DigiMax FS and the FireStudio Lightpipe must be
set to clock externally via BNC. Because of the compact size of the DigiMax D8, it is necessary to use a BNC T-Connector with 3 Female inputs, rather
than the standard Male - Female - Female iteration when using both parallel wordclock distribution and all 8 direct analog outputs at the same time.
FireStudio Lightpipe Mixer set to
clock externally via BNC
FireStudio Lightpipe Mixer set
to Terminate BNC
Using the DigiMax D8 as a Preamp Split
PreSonus Audio Electronics | 7257 Florida Blvd, Baton Rouge, LA USA | Tel: 225-216-7887 | Fax: 225-926-8347 | www.presonus.com | sales@presonus.com
Need help?
General
