TIPS
VEHICLESTORAGE:Ifstoringyourvehicleforextendedperiods,removetheSensors. Mark
each Sensor’s location so it can be replaced on the same tyre location from where it was
removed (eliminating the need for reprogramming), or use a sectional storage device
(similar to a tackle box divider system). When putting the system back on, power up
Monitorfirst,nextscrewSensorsontotheiroriginalwheellocations. Pressurereadingswill
display on Monitor (can take up to 1 minute for new readings to report). PressurePro
systemisnowactive.
CAUTIONS:(1) Know thegeneralcondition oftyresbefore movingthe vehicle. Runningon
deflatedtyrescanruinatyre.(2)The17gmSensor,onatypicalRVorlargetruck,normally
will not require the tyre be rebalanced. Smaller tyres may require rebalancing. (3) It is
importanttomakesurevalvestemsareingoodcondition.
REMOTE ANTENNAFOR UNIQUE APPLICATIONS: Duetothe unique features ofRFsignals
and the construction and interference from electronics on some vehicles, an Optional
AntennaKitorEchoRepeatermaybeneeded.ContactyourDealer/Distributor.
RESETTINGBASELINE PRESSURE: MENU‐> VEHICLE SETTINGS‐>REF PRESSURES‐> AXLE
REFPRESSUREorVEH REFPRESSURE‐>Select Axleor Vehicle‐>Adjustreference pressure
using the UP (^) or DOWN (v) arrows‐> Use the SEL button to save the new reference
pressure
*NOTE: AXLE allows theuser theabilitytocontrolreference pressures by axle, VEHallows
theusertheabilitytocontrolthereferencepressurebasedonthevirtualunitorvehicle
DATALOGGINGCAPABILITIES
PressureProMonitorscomestandard withdata logging capabilities.IfyourMonitoris
powered,it issavingdatasentfrom yourSensors.Thedataloggingcapabilitiesallow
driverstoviewacomplete,time‐stampedhistoryoftheperformanceoftheirtyres
whenmanually downloaded. PressurePro’sTPMS+ Monitor allowstransfer ofthe
completedatalogbywayofamicroSD.Datalogswillexportin.xmlformat,and
workswith manyprograms. PressureProsuggests MsExcel.
ExportInstructions:
MENU‐>VEHICLESETTINGS‐>Logging(ScrollDOWN(v)for
moreoptions)‐>Logging‐>EXPORTLOG
Featuresandbenefitsofthedataloggingfunction
Time stampeddata
Setloggingintervalfrom1to99minutes
Canlogupto45daysofdataformostconfigurationsandloggingintervals
Displaysdataforeachtyre/sensorseparately
Summaryreporttoviewallsystemalertsduringcurrentloggingperiod
Dataprovidedpereachloggingevent
1.
SensorSETofReferencepressure(whichalerts arebasedupon)
2.
Pressureforeachtyre
3.
Tyre temperature
4.
Signalstrengthfrom eachposition
5.
Allalerts
Whatyoucaninferfromthedata
1.
Whenvehicle starts moving.
2.
Whenvehiclecomestostopforlongperiodsoftime(>15minutes).
3.
Dangerousoperatingconditions. Temperatureis displayedatall times,specifically
whenthetyretemperaturehasreachedthedangerzoneof100°C(>200°F). Tyre
rubbercompoundsbegintobreak downatthesetemperatures.
4.
Ifpropercoldpressuresare beingmaintained.
5.
Whensensorsareremovedfromtyreandforhowlong.
6.
Whenatyrebegantoloseair,whenitalarmedandhowlongitraninanalert
condition.
7.
Whendata loggerwas turnedoff.(Optionally Password Controlled)
8.
Validation of driver statements.
To Next Page
Loading...