Getting started
Start recording
1. Insert a micro SD card (not included).
2. Connect the device to the car charger. When the car engine
starts, the device will begin loop recording.
Taking photos
• Press [MODE] to select the picture mode, and then press
[REC] to take photos.
Settings
In preview mode, press [MENU] to enter settings. Use [ ]/[ ]
to navigate the menu.
Video settings
• Resolution: Select the resolution of recorded video:
1080FHD / 1920x1080, 720P / 1280x720, VGA / 640x480.
• Loop recording: Set the video duration for loop recording.
When the micro SD card is full, the device will delete the
first unlocked video file automatically.
• Motion detection: Turn on or off motion detection. If there
is any motion detected while the car engine is stopped,
your car DVR will start recording automatically.
Picture settings
• Capture mode: Select the capture mode from Single /2S
Timer/ 5S Timer/ 10S Timer.
• Resolution: Select the picture image size from 12M /
4000x3000, 8M / 3264x2448, 5M / 2592x1944, 5M /
2592x1944, 3M / 2048x1536, VGA / 640x480, 1.3M /
1280x960, VGA / 640x480.
• Burst: Select to turn the burst on or off.
• Quality: Select quality from Fine / Normal / Economy.
General settings
In preview mode, double press [MENU] twice to enter
general settings.
Playback and media connection
Playback mode
In preview mode, press [MODE] to select playback mode.
1. Press [ ]/[ ] to scroll through the files.
2. Press [OK] to start playback.
3. Press [MODE] again to exit playback mode.
Note:
While viewing the file list, you can press [MENU] to select to:
• Delete one file or all the files.
• Protect or unprotect the selected file.
To Next Page
Loading...
