3.
Settings
Before recording, you can set up the device according to your requirements.
- In video/picture preview mode, press [ ] to enter video/picture settings,
press [MODE] to go to general settings, press [ ] again to exit.
- In setting list, use [ ]/[ ] to navigate the menu, press [ ] to confirm the
selection, and [MODE] to exit.
Video settings
• Resolution: Select the resolution of recorded video: 1080FHD / 1920x1080(30 fps), 720P /
1280x720(60 fps), WVGA / 1280x720(30 fps), VGA / 640x480(30 fps).
• Loop recording: Set the video duration ( 1, 3, 5, or 10 minutes) for loop recording. When the
microSD card is full, the device will delete the oldest unlocked video file automatically.
• HDR: HDR brings out the details of both the highlights and shadows, even in high contrast
lighting.
• Motion detection: Turn on or off motion detection. If there is any motion detected while the car
engine is stopped, your car DVR will start recording automatically.
• Power on record: Set DVR to start recording when power on.
• Power off delay: Select a time span for DVR to power off when the car engine stops.
• Power on delay: Select a time span for DVR to power on when the car engine starts.
• Record audio: Set to turn the microphone on or off.
• G-sensor set: Select the sensitivity of the G-sensor. When reaching the sensitive value (such as
collision), the recording file will be automatically protected.
• GPS auto update time: Set the GPS to update the date/time automatically.
• GMT setup: Select the local GMT (Greenwich Mean Time).
Picture settings
• Resolution: Select the picture image size.
• Capture mode: Select the capture mode from Single/ 2S Timer/5S Timer/10S Timer.
• Sequence: Turn on to capture three photos continuously.
• Quality: Select quality from Fine / Normal / Economy.
• Sharpness: Adjust the sharpness.
• Color: Select color from normal / black & white / sepia.
• Quick review: Set photo review time (2s, 5s) after shooting in preview mode.
General settings
• Date/Time: Set date and time on device.
• Car number set: Set the car plate number if necessary.
• Stamp: Add information stamp onto videos/photos.
• Auto power off: Set automatic power off when the device is not in use.
• Auto LCD off: Set automatic LCD off when the device is not in use, press any button to wake up.
• Beep sound: Turn on or off beep sound.
• Language: Choose your language.
• Format: Format the memory card.
Formatting will erase all your stored data. Back up your data before proceeding.
• TV mode: Choose your TV type from NTSC, and PAL.
• Frequency: For a given luminance, the frequency of light fluctuation that evokes a sensation of
flicker. Set a right flickering frequency to avoid horizontal stripe interference.
• Volume: Set the playing volume.
• Exposure: Set exposure value to determine how much light the camera’s sensor receives. For
To Next Page
Loading...
