Presto PM-10 - Attaching the Bowl to the Mixer; Attaching the Agitator to the Mixer

To Next Page

To Previous Page

Emergency

Stop Button

Start

Button

Speed

Lever

Bowl

Lift

Safety

Cage

PM-10

PM-20

ATTACHING THE BOWL TO THE MIXER

NOTE: Install the bowl BEFORE attaching the agitators.

1. Lower the bowl by pulling the bowl lift lever forward

and down to its resting position

2. Lift the bowl by the bowl handles and slowly position

the locking pin (located on the rear of the bowl) into the

hole in the middle rear of the cradle. Lower the bowl

onto the pins located on either side of the bowl cradle.

3. Once the bowl is positioned on the cradle, secure the

bowl by pulling each bowl clamp

forward until the bowl is locked tight.

ATTACHING THE AGITATOR TO THE MIXER (i.e., Beater, Hook, Whip)

NOTE: It is easier to install the agitator prior to adding the ingredients into the bowl.

1. Rotate the bowl guard to the left so it rests in the open position. Excessive force used to

open and close the bowl guard may damage the spring lock and bowl guard micro-switch,

and will void the warranty.

2. Slide the agitator slowly upwards onto the planetary shaft ﬁtting the shaft pin through the

slot in the agitator.

3. Rotate the agitator clockwise to secure it onto the planetary shaft.