IMPORTANT NOTES AND INSTRUCTIONS
TAKING POSSESSION OF YOUR MIXER
EXAMINE YOUR NEW MIXER FOR ANY SHIPPING DAMAGE. REPORT ANY SUCH
DAMAGE TO THE CARRIER FOR COMPENSATION. EVERY MIXER HAS LEFT THE
FACTORY FULLY TESTED AND INSPECTED. SHIPPING DAMAGE WHICH MAY
OCCUR DURING TRANSIT IS THE RESPONSIBILITY OF PURCHASER.
Move the crated unit as close as possible to its permanent location. When ready to
uncrate, carefully remove all crating. Carefully place the mixer to a permanent position.
Unit must be installed on a solid, level surface.
INSTALLATION NOTES:
Please ensure that during shipping none of the components have loosened.
Select a location for the mixer keeping these points in mind:
Floor or counter must be level.
Easy access for maintenance and service.
Clearance for operating controls, installing and removing agitators, bowl, or attachments.
Sufficient space for adding ingredients during mixing periods.
TO AVOID SERIOUS PERSONAL INJURY:
ALWAYS install equipment in work area with adequate light and space.
ONLY operate the mixer on a solid, LEVEL, non-skid surface.
NEVER bypass, alter, or modify this equipment in any way from its original
condition. Doing so my create hazards and will void warranty.
DO NOT attempt to lift the mixer alone.
PM-10 & PM-20
The outlet must be 110 Volts and 15 Amps. It should be on a dedicated circuit,
and the electrical installation should be grounded. The circuit breaker protecting
this line should be adequately sized to protect the wires. The line on which the
unit is connected should not operate anything else. The use of an extension cord
is prohibited Never cut the ground pin.
PM-30
The outlet must be 110 Volts and 20 Amps. It should be on a dedicated circuit,
and the electrical installation should be grounded. The circuit breaker protecting
this line should be adequately sized to protect the wires.
TO AVOID SERIOUS PERSONAL INJURY:
DO NOT remove the bowl guard.
DO NOT operate the mixer before reading the instruction manual first.
ALWAYS disconnect or unplug electrical power before cleaning, servicing, or adjusting any
parts or attachments.
ALWAYS keep hands, hair, and clothing away from moving parts.
To Next Page
Loading...