Presto ProFry - Performing a Dry Run

Fig. 26
Rotisserie
engagement
ON/OFF switch
Motor ON/OFF
button
Temperature
control knob
Fig. 27
Fig. 28
Recessed
area
Lifting handle
Pivot handle
Fig. 29
Frying
hooks
Fryer
rim
Step 4 To lock the skewer into place, move both locking tabs so the small end of both keyhole slots are in the center of the
locking plate (Fig. 23B, page 12).
Step5 Alwaysverifythattheskewerislockedinplacebyrmlypullingontheliftinghandle.
Perform a “Dry Run” (without oil in the fryer)
To be sure the skewered turkey is centered on the rotisserie and will fully rotate when placed in the fryer, perform a “dry run”
before adding oil to the fryer.
For a helpful HOW-TO video, visit www.GoPresto.com/how/dryrun/
Step 1 Make sure the rotisserie engagement switch on the pivot handle is in
the OFF position (Fig. 26). Also, make sure the motor button and the
temperature control knob on the control panel are in the OFF position
(Fig. 27).
Step 2 Lift the skewered turkey using the pivot and lifting handles. Position the
rotisserie over the fryer so the pivot handle, the one with the ProFry
™
logo,
is above the control panel. Lower the pivot handle into the recessed area of
the control panel until it is resting securely in place (Fig. 28). Then, lower
the lifting handle until the frying hooks rest on the fryer rim (Fig. 29). It is
important that the hooks are placed over the rim. Otherwise, the rotisserie
will not fully rotate.
Step 3 Attach the power cord to the fryer by aligning the magnetic plug end with
the two electrical pins on the back of the control panel (Fig. 4, page 5).
The plug can be attached in either direction.
Step 4 Plug the cord into a 120VAC electrical wall outlet only. Whenever the unit
is properly connected, the power light will be illuminated.
IMPORTANT: The magnetic cord was designed to detach easily from the
fryer. As a result, if it is bumped or touched during use it could possibly
detach causing the unit to stop working. Avoid contact with cord during
operation. If contact occurs, verify that the cord is still properly connected.
13