PRETUL GEN-55P - Fuel and Oil Management; Engine Oil Supply; Fuel Tank Filling

To Next Page

To Previous Page

Minimum

Maximum

ENGLISH

Fuel and Oil

• Set the generator in a flat and level surface.

• Turn and remove the oil tank cap.

• Fill up the tank with 4-stroke gasoline motor oil SAE

10W-30. Use a funnel.

• Set back the cap and remove to check the oil level in the

cap oil measuring rod.

• Once the tank reached the right level indicated in the

rod. Tighten the cap to prevent leaks.

• Do not exceed the maximum oil level

because it may produce a lot of smoke when starting the

motor.

• Check oil level before each use. If

necessary, add oil until the level is within the limits in the

cap oil measuring rod.

• Replace oil after 50 hours’ operation or

each season. In very dusty or dirty conditions, it may be

necessary to change oil more often.

Oil Supply (A)

• Set the generator in a flat, leveled surface.

• Clean and dry the area around the fuel cap.

• Remove the fuel cap.

• Using a funnel, slowly fill up the fuel tank up to the

lower part of the tank neck. Do not overfill to allow fuel

expansion and prevent spills.

• Clean any fuel spills.

• Cover the tank turning the cap until hearing a click.

• Clean all the fuel spills before starting the motor.

Fuel Supply (B)

CAUTION