5
GC3 Controller
The GC3 controller is a fully-programmable, modular electronic controller system that allows you to
operate your power chair. It is designed to allow the user to have complete control over chair movement
and speed.
The controller has been pre-programmed to meet a typical user’s needs. The program is set using
either a personal computer with software provided by the controller manufacturer or with a hand-held
programmer, also provided by the controller manufacturer.
WARNING! The controller program can affect speed, acceleration, deceleration, dynamic stability,
and braking. If it is programmed incorrectly or outside of the safe limits as determined by your
healthcare professional, it can create a dangerous situation. Only the power chair manufacturer,
an authorized representative of the manufacturer, or a trained service technician should program
the controller.
Precautionary Guidelines
Before operating the GC3 controller, please read the following. These guidelines are provided for your
benefit and will aid you in the safe operation of the control system.
Turn off the power to the controller when transferring to or from your power chair.
Follow all of the procedures and heed the warnings as explained in your power chair owner’s manual.
Electromagnetic and Radio Frequency Interference (EMI/RFI)
NOTE: This product has been tested for and has passed Electromagnetic and Radio Frequency
Interference (EMI/RFI). Please refer to the Consumer Safety Guide for more information regarding
EMI/RFI.
To Next Page
Loading...
Need help?
General