16 www.quantumrehab.com Quantum 6000
QUANTUM 6000 SPECIFICATIONS
Class of Use: B
Suspension: Front and Rear
Drive Wheels: 36 cm, pneumatic (36 cm solid optional)
Caster Wheels: 15 cm solid (rear); 13 cm solid (front)
Maximum Speed: Up to 10 km/h*
Brakes: “Intelligent Braking” electronic regenerative, disc park brake
Ground Clearance: 9 cm
Maximum Safe Slope: 8.7% (5°)
Maximum Climbing
Ability: 8.7% (5°)
Maximum Obstacle
Climbing Ability: 5 cm
Turning Radius: 56 cm (without foot riggings)
Overall Size: Length: 97 cm (without foot riggings)
Width: 65 cm
Seating Options: Synergy Seat
Power Elevating Seat
Synergy Manual Tilt
High-back Contour Seat
Manual Recline High-back Contour Seat
Synergy TRU-Balance Power Positioning Systems
Drivetrain: Two motor, Mid-wheel-6 drive
Batteries: Two Group 24 batteries (standard) (AGM or Gel-Cell recommended)
Two 12-volt, NF-22 required with Power Elevating Seat
Two Group 34 batteries required with Synergy TRU-Balance Power Positioning Systems
Range: Up to 40 km*
Battery Charger: Off-board
Motor Controller: 100-amp Remote Plus
100-amp Microdrive
Weight Capacity: 136 kg (72 kg with Synergy Manual Tilt)**
Component Weights: Base: 77 kg
Synergy Seat: 27 kg
Batteries: 23 kg each
*Depending on user weight and terrain.
** This power chair has been successfully tested to a maximum user weight capacity of 100 kg in order to comply with
Australian testing standards. Additionally, the power chair manufacturer has successfully tested the power chair to a maximum
weight capacity of 136 kg. Further information regarding the performance attributes and testing results of the power chair may
be obtained by sumbitting a written request to Pride Mobility Products Australia Pty. Ltd., Attn.: Technical Services.
III. YOUR POWER CHAIR
To Next Page
Loading...
