EasyManua.ls Logo

Pride Mobility TSS300 - APPENDIX I - SPECIFICATIONS; TSS300 TECHNICAL SPECIFICATIONS

Pride Mobility TSS300
44 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
TSS300 39
APPENDIX I - SPECIFICATIONS
1
Varies with base model, user weight, terrain type, battery amp hour rating (Ah), battery charge, battery condition, motors,
controller type, tire type, and tire condition. This specification can be subject to a variance of (+ or -) 10%.
2
Due to manufacturing tolerances and continued product improvement, this specification can be subject to variance of (+
or -) 3%.
3
AGM or Gel-Cell type required. See VI. “Batteries and Charging.”
4
Tested in accordance with ASNI/RESNA WC Vol 2, Section 4 and ISO 7176-4 Standards. Results derived from
theoretical calculation based on battery specifications and drive system performance. Test conducted at maximum
weight capacity.
5
Battery weight may vary based on manufacturer.
NOTE: This product conforms to all applicable ANSI-RESNA testing requirements and ISO 7176 series EN12184
standards. All specifications subject to change without notice.
TSS300 SPECIFICATIONS
Suspension:
Limited
Drive Wheels: 9 in. (22.86 cm), solid
Caster Wheels: 6 in. (15.24 cm), solid, rear-mounted
Anti-tip Wheels:
3 in. (7.62 cm), solid, front-mounted
Maximum Speed:
1
Up to 4.0 mph (6.44 km/h)
Range:
1, 4
Up to 15 miles (24.14 km)
Brakes: “Intelligent Braking” electronic regenerative, disc park brake
Ground Clearance:
2
See figure 22.
Maximum Safe Slope: (10.5%)
Turning Radius:
2
See figure 22.
Overall Size:
2
See figure 22.
Drivetrain:
Two motor, Front-wheel drive
Batteries:
3
Two 12-volt, U-1 batteries
Battery Charger: 3-amp, off-board
Weight Capacity:
300 lbs. (136 kg)
Component Weights:
5
Base: 68.5 lbs. (31.07 kg)
Standard Seat (High Back): 50 lbs. (22.68 kg)
Batteries: 24.5 lbs. (11.11 kg) each

Related product manuals