Pride go-go ultra - User Manual

Questions and Answers

D
dustin56Aug 13, 2025
What to do if the motor runs but my Pride Scooter does not move?
- K
  Kevin HernandezAug 13, 2025
  If the motor runs but your Pride Scooter doesn't move, pull the manual freewheel lever rearward to restore normal operation.
K
Karen KingAug 16, 2025
Why won't my Pride go-go ultra turn on?
- L
  Lisa PerryAug 17, 2025
  If your Pride Scooter won't turn on, it may be because the battery voltage is too low. Charge it fully until the charger and any meters indicate completion.
H
Heather PerryAug 20, 2025
What to do if all systems on my Pride Scooter are dead?
- M
  mhaysAug 20, 2025
  If all systems on your Pride Scooter appear 'dead', try the following: * Ensure the key is fully inserted into the key switch. * Verify the batteries are fully charged. * Confirm the battery pack is correctly seated. * Press the main circuit breaker’s reset button. * Ensure the front-to-rear harness is firmly connected. * Check if the power down timer feature has been activated.
B
baileycolinAug 25, 2025
What to do if the battery condition meter dips and the Pride go-go ultra Scooter motor surges?
- M
  mindy31Aug 25, 2025
  If the battery condition meter dips way down and the motor surges or hesitates when you press the throttle control lever on your Pride Scooter, take these steps: * Fully charge the scooter’s batteries. * Have your authorised Pride Dealer load test each battery.
C
Cindy SmithAug 28, 2025
What to do if the main circuit breaker trips repeatedly on my Pride go-go ultra Scooter?
- J
  Jasmine CraigAug 28, 2025
  If the main circuit breaker trips repeatedly on your Pride Scooter: * Charge the scooter’s batteries more frequently. * If it continues, consult your authorised Pride Dealer for service.
H
Hailey DonaldsonAug 31, 2025
What to do if my Pride go-go ultra Scooter controller trips?
- M
  Michael DavisAug 31, 2025
  If you suspect a controller trip on your Pride Scooter, either because you were installing the battery pack with the key inserted or the motor controller is in overheat protective mode: * Shut down your scooter for several minutes to allow the controller to cool. * Try reinserting the key into the key switch.
D
Dylan SawyerSep 4, 2025
What to do if my Pride Scooter has a solenoid brake trip?
- D
  Dana CastilloSep 4, 2025
  If your Pride Scooter experiences a solenoid brake trip, it might be because the manual freewheel lever is in the freewheel position. To resolve this, remove the key, push the manual freewheel lever to the drive position, and then restart your scooter.
M
Maureen CampbellSep 8, 2025
What to do if my Pride Scooter has a throttle trip?
- S
  stephaniejohnsonSep 8, 2025
  If your Pride Scooter experiences a throttle trip because the throttle control lever was depressed while inserting the key, release the throttle control lever completely, then reinsert the key.