EasyManua.ls Logo

Pride MILFORD - WEIGHT LIMITATIONS; INSTALLATION; PRE-LIFT INSPECTION

Pride MILFORD
20 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Milford Person Lift www.pridemobility.com 6
WEIGHT LIMITATIONS
The lift system is designed to lift a maximum user weight of 330lbs (150 kg). Depending on the way the
lift system is set up for the vehicle, this maximum weight limit may be reduced. Please refer to the
specification table to check the maximum capacity for your specific installation. Keep in mind that the
maximum weight capacity includes the combined weight of the user and any accessories mounted to
the lift arm.
MANDATORY! Stay within the specified weight capacity of the lift system.
Exceeding the weight capacity voids your warranty. Pride will not be held
responsible for injuries and/or property damage resulting from failure to observe
weight limitations.
INSTALLATION
WARNING! The Milford Person Lift is only intended to be installed by an
authorized Pride installer or qualified technician. Separate installation
instructions are provided with the installation kit. Read and fully understand
both manuals prior to installation.
NON-PRIDE PRODUCTS
Use only the sling provided with the Milford Person Lift. Other slings by different manufacturers may
have a different balance point, different attachment points and will not be suitable for use with this type
of device. Pride accepts no liability for damage or injury caused by the use of inappropriate slings.
PRE-LIFT INSPECTION
There should be no sharp edges on either the Milford Person Lift or the fitting kit. If you find any sharp
edges, please contact your supplier before use.
Please make sure that you are completely happy with the operation of your Milford Person Lift before
operating it yourself. Misuse of the product could result in injury.
Inspect the sling and straps before every use for twisting, fraying or signs of wear. If signs of wear
become evident, have the sling replaced by your authorized Pride Provider. Check that the buckles have
not moved and that the positioning of the person being lifted is correct at the start of the lift. Refer to
the technical section for the correct method of threading the straps through the buckles to avoid
slipping.
WARNING! A frayed or worn strap can snap, resulting in injury to the person being
lifted and/or the operator. Do not use a damaged sling.
I I . S A F E T Y

Related product manuals