the handle installed already. If it is already installed, you can
remove it by unscrewing the handle, if you would like to re-
position the handle to the other side of the unit.
Next you need to select the appropriate shell holder for the
cartridge you intend on priming. Shell holders are not included
with the CPS and must be purchased separately. Any shell holder
for use in a Lee AutoPrime, 21
st
Century, or Sinclair priming tool
should work in the CPS.
Once you have selected the correct shell holder, remove the shell
holder retainer by unscrewing the cap screws in the top of the
shell holder retainer and remove it.
With the shell holder retainer removed, you need to install the
correct primer conversion for the cartridge you are priming.
Please consult your reloading manual if you are unsure of what
primer size your cartridge requires. Once you have selected the
proper primer conversion, install it by placing the shuttle hanger
into the elevator, ensuring the locating pin is inserted into the
hole on the bottom-front of the shuttle hanger.
Once the shuttle hanger is installed, place your chosen shell
holder on top of the shuttle hanger, and then place the shell
holder retainer on top of the shell holder. Insert the shell holder
retainer screws, and tighten them evenly to ensure even pressure
is applied on the top of the shell holder.
DO NOT USE A TOOL TO TIGHTEN THE SHELL HOLDER
RETAINER SCREWS!!!!!!
Use your fingers only! Using a tool is not necessary and may
damage the elevator assembly. If you cross thread, or otherwise
To Next Page
Loading...