Unboxing your CPS
When you unbox your CPS, you will find the items above, as well
as both small and large primer conversion. A primer conversion
consists of a shuttle hanger, shuttle, shuttle lever, and priming
rod.
To begin using your CPS, you must ensure that it is properly
mounted to your bench. How you mount it will depend upon your
specific reloading bench setup. The holes in the rear of the base
are provided so that you may use large lag screws, bolts, or a
fastener of your choosing to tightly and rigidly mount the CPS to
your bench.
After the CPS is mounted properly, install the handle by screwing
the handle into either side of the ram rotor. Your CPS may have
To Next Page
Loading...