EasyManua.ls Logo

Prime ARTEMIS - Specifications

Default Icon
44 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Artemis www.pridemobility.com 41
APPENDIX I - SPECIFICATIONS
SPECIFICATIONS
Suspension Rear-wheel drive
Drive Wheels
30.48 cm (12 in.), centre-mounted, pneumatic, standard
Castor Wheels 20.32 cm (8 in.), front articulating, solid, standard
Anti-tip Wheels 30.48 cm (12 in.) standard
Maximum Speed¹
Up to 6.43 km/h (4 mph)
Brakes
“Intelligent Braking” electronic regenerative, disc park brake
Ground Clearance²
See figure 28.
Turning Radius²
See figure 28.
Overall Size²
Length: See figure 28.
Width: See figure 28.
Drivetrain Two motor, rear-wheel drive
Batteries³ Two 60 Ah Group 34 batteries
70 Ah Group 24 batteries (optional)
NF-22 batteries (optional)
Range
1, 4
Up to 19.31 km (12 miles) with standard batteries
Up to 25.75 km (16 miles) with optional batteries
Battery Charger 5-amp, off-board
Weight Capacity 136 kg/21 stone/300 lbs.
Component Weights
Base and Seat: 83 kg (183 lbs.) with pneumatic drive wheels; batteries not included
Batteries: 24 kg (53 lbs.) each
(Group 24); 19.5 kg (43 lbs.) each (Group 34); 18 kg (40 lbs.)
each (NF-22)
Class of Use
Maximum Safe Slope
Maximum Climbing Ability 10.5% (6°)
Maximum Obstacle Climbing
Ability
7.6 cm (3 in.)
10.16 cm (4 in.) with optional kerb climber
10.5% (6°)
B
1
Varies with base model, user weight, terrain type, battery amp hour rating (Ah), battery charge, battery con-
dition, motors, controller type, tyre type and tyre condition. This specification can be subject to variance of (+
or - ) 10 %.
2
Due to manufacturing tolerances and continued product improvement, this specification can be subject to
variance of (+ or – ) 3%.
3
AGM or Gel-Cell type required. See V. “Batteries and Charging.”
4
Tested in accordance with ASNI/RESNA, WC Vol 2, Section 4 and ISO 7176-4 standards. Results derived
from theoretical calculation based on battery specifications and drive system performance. Test conducted at
maximum weight capacity.
NOTE: This product conforms to all applicable ANSI-RESNA testing requirements and ISO EN12184
standards. All specifications subject to change without notice.