4. Apply Teflon anti-sieze grease to the non-drive side bearing surface on the axle highligted in red. Fit the replacement
non-drive side bearing, bearing dust seal and non-drive side end cap on to the axle
5. Apply Teflon anti-sieze grease onto area highlighted in red on the hubshell. Place the hub/wheel on the hub support
tool, then taking the dead blow or rubber mallet knock the axle and hardware on the axle into the hubshell . Do this by
hitting the end of the axle end cap on the non-drive side highlighted in red.
16
To Next Page
Loading...