It is advised that a test ride is performed once the the hub re-assembly is complete to ensure that everything
has been fitted correctly.
If performing a test ride it is advised that all necessary safety gear is used to prevent any form of injury.
13. Slide the freehub onto the axle of the main hub. Ensure that the ratchets seat correctly within the hubshell and
freehub, with the freehub pushed as far as it will sit on the axle.
14. Press on the drive side endcap and ensure that it is firmly positioned on the axle.
This concludes the assembly and bearing replacement of the Prime rear SR hubs. The cassette and disc rotor can now be
re-attached and the wheel inserted into the bike.
21
To Next Page
Loading...