If the freehub dust seal is fitted either with the incorrect orientation, unevenly or not fully inserted this can
cause friction between the freehub and seal. This then will lead to poor rotation of the wheel and drag on the
freehub.
12. Press in the bearing dust seal into the freehub. Ensure that it is pressed in evenly and seated against the outer
bearing on the freehub.
11. Apply Teflon anti-sieze grease the surface highlighted in red on the freehub body. Then using the bearing press
with the correct press for the freehub body bearing, insert the bearing spacer and outer freehub bearing until it is fully
seated within the freehub. The bearing spacer should sit firmly between the inner and outer freehub bearing.
20
To Next Page
Loading...