TOOLS AND CONSUMABLES REQUIRED FOR ASSEMBLY
- Isopropyl Alcohol
- Cleaning Cloth
- Anti-Seize Grease (Teflon based)
- Star Ratchet Grease
- Star Ratchet Ring Removal Tool
- Bearing Removal Tool - Compatible with with all necessary bearings
- Dead Blow Mallet or Rubber Mallet
- Drift
- Bearing Press Fit Tool - Compatible with with all necessary bearings
- Circlip Pliers
- Vice
- Workshop or Latex Gloves
- Protective Eye Wear
- Small Flat Head Screw Driver
- Torque Wrench with 24mm Socket or Crow Foot Spanner
- Hub Support Tool
The following section goes through the tools required to perform the correct proceedure to disassemble and
re-assemble the Prime hubs for bearing replacement
TOOLS
Lifeline Pro Inner Ratchet Nut Removal Tool
https://www.wiggle.com/p/lifeline-pro-inner-ratchet-hub-nut-
removal-tool
Bearing Pro Ring Nut Lockring Tool (Star Ratchet)
https://www.bearingprotools.com/products/ring-nut-lockring-
tool-star-ratchet-for-dt-swiss-180-240-240s-350-rear-
hubs?variant=39677295067241
Lifeline Pro Bearing Press Set https://www.wiggle.com/p/lifeline-pro-bearing-press-set
Wheels Manufacturing Bearing Press Pro Kit
https://wheelsmfg.com/presses-tools/presses-
extractors/bearing-press-pro-kit.html
Bearing Removal Tool Bearing Pro Bearing Puller for Bikes (Expanding Type)
https://www.bearingprotools.com/products/bearing-
puller?variant=6945738915898
Star Ratchet Ring Removal
Tool
Bearing Press F
it Tool
Please note that the use of incorrect tools may cause damage to the hub and will void all warranty. The above
tools are recommend by Prime and are proven the correct tools to carry out the bearing replacement.
4
To Next Page
Loading...