Primedic HeartSave - Table of Contents

Table of contents
III
Table of contents
1 Introduction HeartSave AED Trainer 4
1.1 Foreword 4
1.2 Validity 4
1.3 Intended use 4
1.4 Guarantee 4
1.5 Disclaimers 5
2 Description of device 6
2.1 Description of device details 6
2.2 Description of the accessories 9
2.2.1 SavePads Trainer Electrodes 9
2.2.2 SavePads Trainer Cable 9
2.2.3 Accessories 10
3 Preparatory measures before (initial) start-up 11
3.1 Unpacking 11
3.2 Inserting / Replacing the Batteries in the Power Module 11
3.3 Inserting / replacing the energy module 12
3.3.1 Inserting the power module 12
3.3.2 Removing the power module from the device 13
3.4 Inserting / replacing the SD card 13
3.5 Entering the Device Code for Remote Control 14
4 Using the device 15
4.1 Enable / Disable the PRIMEDIC™ HeartSave AED Trainer 15
4.1.1 Turn on the PRIMEDIC™ HeartSave AED Trainer 15
4.1.2 Turn off the PRIMEDIC™ HeartSave AED Trainer 15
4.2 Resuscitation Sequence 15
4.2.1 Selection of Resuscitation-Scenarios 15
4.2.2 Pediatric Mode 17
4.2.3 Conditions for the Start of the Analysis 18
4.2.4 Automatic start of analysis 18
4.2.5 Adapting the volume of the metronome 18
5 ERC/AHA Guideline 2010 19
5.1 Voice output of the device 19
5.1.1 Defibrillation necessary: 19
5.1.2 Defibrillation is not necessary: 19
5.2 Cardio pulmonary resuscitation 20
5.3 Message < Check electrodes > 20
6 Cleaning 21
7 Disposal 21
8 Technical Data 22
9 Warranty conditions 23
!
The PRIMEDIC™ HeartSave AED
Trainer is no active defibrillator and is
therefore not suitable for the therapy to
patients.
!