ENGLISH
7
2 USE
2.1 Controls
The screen has 4 displays with 7 segments each and gives information regarding
the current operation.
The switch has two positions. Press “I” to switch on the washing machine and “O” to
switch it off.
Press Start to start a programme, pause or continue the programme after the
pause. In the menu navigation use the ENTER function to enter or go the next level
in a menu.
Press advance to accelerate a programme. When this key is pressed the
programmer goes directly to run the next phase of the programme; where the phase
currently running is the last, the programme ends. Please note that if you press this
key during a spin cycle, the machine will not move to the next phase until
completion of the required safety time to permit the drum to come to a complete
standstill.
INC ( ) and DEC ( ) keys
The INC () and DEC () keys have different functions depending on the screen
and the programmer operating mode. Use these keys to select a wash programme
or to scroll through different menus.
Press Express to reduce the time each programme runs. The following table shows
the effect of the “express” key on the different programmes.
When the Express key is pressed, the letter S appears next to the programme,
indicating that the express mode is on.
When scrolling through the menus, use the Return function to exit or go to the
higher level.
Press this key to add an additional rinse to the current washing programme. When it
is pressed, the additional Extra Rinse LED lights up.
The programmer has 7 amber LEDs that indicate the status of the washing machine
and the washing programme progress in its different phases. The eighth LED is
green and shows the door status.
2.2 Programmes
(S) Express mode on
The complete prewash cycle is cancelled and the wash cycle lasts 8
minutes instead of 12.
The complete prewash cycle is cancelled and the wash cycle lasts 10
minutes instead of 15.
The complete prewash cycle is cancelled and the thermal stop is
deactivated in the wash cycle
Whites/coloureds cold wash
The complete prewash cycle is cancelled.
The complete prewash cycle is cancelled and the wash cycle lasts 10
minutes instead of 15.
The complete prewash cycle is cancelled.
The complete prewash cycle is cancelled and the thermal stop is
deactivated in the wash cycle
The complete prewash cycle is cancelled.
The complete prewash cycle is cancelled and the wash cycle lasts 8
minutes instead of 12.
NOTE: When the thermal stop is deactivated, the programmed wash time starts to run immediately without waiting for the programmed water
temperature to be reached
To Next Page
Loading...
