EN
Página 34 de 43
9. Central Message: Until the full payment for the programme has been made, the
message "INSERT COIN", "INSERT CARD" or "MAKE PAYMENT", depending on the
selected mode, is displayed in the centre of the window. This message will disappear on
completion of the payment.
To run any programme, the corresponding payment must first be made. Depending on the existing
self-service configuration, the machine controls the insertion of coins (COIN mode) or receives the
corresponding signal in CP or CR mode via the “coin slot micro” input to allow the selected
programme to run.
If the machine is configured in COIN mode, as the coins are inserted, the price decreases. It is
possible to change programme after the user has started to insert coins. The amount inserted is
stored and then deducted from the price of the new programme selected. When the amount
reaches 0, the START button is displayed to permit the programme to be run.
The last coin may exceed the amount remaining. If the programme is run, the extra amount will be
lost. But if the programme is changed, the machine stores the total amount inserted and deducts it
from the price of the new programme.
If there is no activity within 30 minutes, the machine automatically switches to the Standby Screen,
resetting any credit that may be stored.
While in self-service mode, it is possible to go to “Credit mode”. If the “top open” input is
activated, a password is requested to enter “Credit mode”.
When the machine enters “Credit mode”, it automatically exits self-service mode and behaves as if
it were in normal mode, displaying the information defined on the OPL Main Screen and offering
the option to perform all the actions defined on this screen. The programmes selected for self-
service and the programmes defined for Credit Mode are displayed.
On going to the main menu, all the available options for self-service washing machines are
displayed.
If the “top open” input is deactivated, the machine exits from “Credit mode” automatically. If the
machine is in a secondary screen of the main menu (configuration, maintenance…) and it exits
“Credit Mode”, it acts as if it were in this mode until exiting the Main Menu (saving the changes).
Once the machine has reached the Main Screen, it exits credit mode.
To Next Page
Loading...
