Section 1
Specification
The wire end may deal damage, please note the following.
WARNING
• Never look into the electric conduction hole when checking the wire feeding is
normal or not, or the shooting wire may stab your eyes and face.
• Keep your eyes, face or other naked parts away from the end of torch when
feeding the wire manually or pressing the switch.
For better work efficiency and power source maintenance,
please note the following.
WARNING
• Precautions against toppling over.
• Never use the welding equipment for pipe thawing.
• Lift the power source from side when use the up-down forklift truck to avoid
toppling over.
• When using the crane for lift, tie the rope to the ears with an angle no more
than (P15 to the vertical direction.
• When lifting the welding machine which equipped with gas cylinder and wire
feeder, download them from the power source and ensure the horizontal of the
machine. Do fix the gas cylinder with belt or chain when moving it to avoid body
hurt.
• Ensure fastness and insulation when lifting the wire feeder through the swing
ring for welding.
Electromagnetic interference needing attention.
WARNING
• It may need extra preventive measures when the equipment is used in
particular location.
• Before the installation, please estimate the potential electromagnetism
PRIME-WELD CUT 60 User Mannual
8
To Next Page
Loading...
